Savin 2513f Instruções de Operação descarregar pdf (Página 63)

NetWare 3.x - Advanced Settings

Setting Up as a Remote Printer

Log on to the file server as a Supervisor or a Supervisor equivalent.

Run the NIB Setup Tool.

Reference

⇒ P.42 “Running the NIB Setup Tool”

Click [Property Sheet] and click [OK].

The [NIB Setup Tool - Network board list] dialog box of the Network Interface

Board appears.

Click [IPX protocol].

Click the IPX address of the Network Interface Board which is to be config-

ured, and click [Next >].

Note

❒ If you do not know which Network Interface Board you are configuring,

see a network configuration page to check the MAC address (Network Ad-

dress).

Make sure that the MAC address and IPX address are correct, and click [Fin-

ish].

The [NIB Setup Tool] window appears.

Click [Configure].

The property sheet appears.

Click the [General] tab, and type the name of the print server into the [Device

Name] box.

Click the [NetWare] tab, and make the following settings.

A In the [Print Server Name] box, type the name of the print server.

B In the [File Server Name] box, type the name of the file server in which a

print server is to be created.

Clicking [Browse], you can select a file server among those listed in the

[Browse] dialog box.

C In the [Print Server Operation Mode] group, click [As Remote Printer].

D In the [Remote Printer No.] box, type the printer number.

Important

❒ Use the same printer number as that to be created in the printer server.

E Click [OK] to close the property sheet.

F After the confirmation dialog box appears, click [OK].

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 111 112

Sem comentários

Savin 2513f Instruções de Operação Página 63