
12 March 1999 OTHERS
SM 6-27 G031/G032
Replacement
and
Adjustment
6.6.3 ENGINE CONTROL BOARD REPLACEMENT
CAUTION
Before replacing the engine control board, do the following:
Make sure that there is no print data in the printer buffer (the Data In LED must
not be lit or blinking).
It there is some data in the buffer, wait until all data has been printed.
NOTE:
Before replacing the engine board, print out the print log (see “Service
Program Mode - Print Log” in section 4).
1. Remove the control board cover. (Refer to Control Board Cover Removal,
section 6.1.3.)
2. Replace the engine control board [A]. (4 screws and all connectors).
3. Take the EEPROM (IC5) [B] off the old board, and put it on the new board.
G031R537.WMF
[A]
[B]
Comentários a estes Manuais