Savin SLP20 Manual de Serviço descarregar pdf (Página 263)

USING A DIMM

SM A-15 G031/G032

APPENDIX

2. Click the Byte Swap button.

3. Select the source file name (eg. P3card.rom) from the file list.

4. Enter the destination file name (eg. P3carddwn.rom).

NOTE: Any destination file name can be used. However, the recommended file

name is XXXdwm.rom. Using a standard naming system such as this

will prevent confusion later.

5. Click Enter then click Exit. In the source file directory, XXXdwn.rom is created

as the byte-swapped file.

Downloading to the DIMM card

The firmware can be downloaded either with the Windows SSU utility or using MS-

DOS. Any firmware already included on the DIMM card will be overwritten.

Stinger Service Utility

First, prepare the printer.

1. Turn off the printer.

2. Change DIP SW1 to ON on the printer control board.

3. Connect the IC card to the IC card adapter, then connect the adapter to the

option bus connector on the printer control board.

NOTE: G031 has two option bus connectors. The left side connector is used

for the downloading.

The IC card must contain firmware for the printer; a blank IC card will

not boot up the printer.

4. Plug the DIMM card into the printer control board.

5. Turn on the printer. Then the printer will boot from the firmware in the IC card.

• The service menu will appear as follows.

G031X540.PCX

Stinger Service

1. Update Firmwr

G031X537.WMF

CÓPIA NÃO CONTROLADA

1 2 ... 258 259 260 261 262 263 264 265 266 267 268 ... 273 274

Sem comentários

Savin SLP20 Manual de Serviço Página 263