Savin SDC306 Instruções de Operação Página 40

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 54
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 39
Installation and Operating Instructions
SDC 306 1316BED036-11B-E Date 06/09
- 40 -
11.9 Basic system diagram 9:
1 collector array, 2 storage cylinders (hot water and buffer), return line temperature
increase
System 9 has one collector surface, two
storage cylinders, one solid fuel boiler and
one return line temperature increase. The
control unit controls the solar function
(temperature difference regulation for 2
storage cylinders, priority logic), and the
return line temperature increase
(temperature difference regulation). Heat
metering is also possible, e.g. using an
impeller flow meter.
Information Program Manual operation Basic setting
I I I I
Current collector temperature (E1) Maximum temperature of
storage cylinder 1
Pump A1 off/on Code entry
Minimum collector temperature (E1) Solar circuit storage 1 Td Start
A2 off/on Reset/factory setting
Maximum collector temperature (E1) Solar circuit storage 1 Td Stop
A3 off/on Select basic
configuration
Current temperature of storage cylinder 1
at bottom (E2)
Maximum temperature of
storage 2
A4 off/on Maximum collector
temperature
Minimum temperature of storage cylinder
1 at bottom (E2)
Solar circuit storage 2 Td Start
Priority storage cylinder
Max. temp. of storage 1 at bottom (E2) Solar circuit storage 2 Td Stop
Mode yield metering
Current temp. of storage 2 at top (E4) R2 Td start
Volume flow
Minimum temp. of storage 2 at top (E4) R2 Td stop
DFG/WMM
∗∗
Maximum temp. of storage 2 at top (E4)
Set time
Glycol type
Current return line temperature (E5)
Glycol percentage
Minimum return line temperature (E5) Maximum temperature
return line heating
Maximum return line temperature (E5) Code change
Current temp. of storage 2 - bottom (E3)
Min. temp. of storage 2 - bottom (E3)
Max. temp. of storage 2 at bottom (E3)
Flow rate
Daily yield 1/2
Total yield 1/2
Displayed only if yield metering mode is equivalent to 1 or 2.
∗∗ Displayed only if yield metering mode is equivalent to 2.
Vista de página 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 53 54

Comentários a estes Manuais

Sem comentários